G3LC 1KHW000621R0001 Medium-Voltage Circuit Breaker

1. Pre-Operation Preparation

1. Confirm the power supply of the G3LC 1KHW000621R0001 device is in the “OFF” state to avoid electrical hazards during preparation.
2. Inspect the physical condition of the device:
   • Check for visible damage to the housing, terminals, or connecting wires (e.g., cracks, fraying, or loose connections).
   • Ensure the device’s display screen (if equipped) is clean and free of smudges that could affect readability.
3. Verify the correctness of external connections:
   • Confirm that input/output (I/O) terminals are properly connected to external equipment (e.g., sensors, controllers, or actuators) as per the wiring diagram.
   • Ensure all terminal screws are tightened to prevent poor contact.
4. Check the surrounding environment: Ensure the device is installed in an area that meets ABB’s specified conditions (e.g., temperature: -5°C to 40°C, humidity: ≤85% non-condensing, no excessive dust, vibration, or corrosive gases).

2. Power-On Procedure

1. Turn on the main power switch of the device’s power supply circuit (e.g., a dedicated circuit breaker).
2. Flip local power switch to the “ON” position.
3. Observe the device’s startup status:
   • The power indicator light should illuminate steadily (typically green; refer to the manual for indicator definitions).
   • If the device has a display, it should show the startup screen or default operating interface without error codes (e.g., “E001” for power faults). If an error code appears, shut down the device immediately and troubleshoot according to the manual.
4. Allow the device to complete the self-test (usually takes 30 seconds to 1 minute). Confirm that no abnormal sounds (e.g., buzzing) or overheating occur during self-test.
5. 

3. Parameter Setting (if configuration adjustment is required)

1. Enter the parameter setting mode: Press the “Menu” or “Set” key on the device’s operation panel (or via a connected ABB configuration software, e.g., ABB Control Builder) until the “Parameter Setup” interface is displayed.
2. Navigate to target parameters: Use the “Up/Down” or “Left/Right” arrow keys to select the parameter group (e.g., “Input Configuration,” “Output Logic,” “Protection Settings”) and the specific parameter to adjust.
   • Example parameters: Input signal type (4-20mA/0-10V), output action threshold, overcurrent protection value.
3. Modify parameters:
   • Press the “Edit” or “Enter” key to activate the parameter editing state.
   • Use the arrow keys or numeric keypad (if equipped) to input the desired value. Ensure the value complies with the system design requirements and ABB’s recommended ranges.
4. Save parameters: After confirming the value is correct, press the “Save” or “OK” key. The device will usually display a “Save Successful” prompt; if not, recheck the operation.
5. Exit parameter mode: Press the “Back” or “Menu” key repeatedly to return to the main operating interface.
6.